This Balboa circuit board part number 52320 is a replacement for the Balboa Digital circuit board in the Duplex Digital M7 systems. Chip Number on this circuit board 2000M7.
&
Circuit board details:
- Chip # 2000M7
- Compatible replacement for: See below
- Part Number: 52320-01
System outputs:
- 230V Pump 1, 2-Speed
- 230V Pump 2, 1 or 2-Speed
- 230V Blower
- 120V Ozone
- 12V Spa Light
- 230V 5.5KW Heater
- 120V Circ Pump
Compatible replacement for:
The Balboa 52320 is a compatible replacement for the following alternate spa Balboa boards and private labeled Balboa equipment part numbers: 52319, 53864, 52941, 52702, and 53863-04.
Compatible with the following topside controls: 53189, 51057, 54156, 50949, 54086, 51574, 52403, 52404 and 52405.
Works with sensors 30382 and 32016 for M7 systems.
Returns:
Hot Tub circuit boards are non-returnable items as they cannot be resold. All the replacement circuit boards we sell are factory-new, factory-tested and have never been installed before. For further information, please refer to our return policy. All circuit boards come with the original manufacturer's warranty.
It is very important that you do not order a circuit board based on looks, many Balboa circuit boards look alike but have different software and or chips on them that changes the functionality and features. It is the firmware on the chip that manages the circuit board and gives it its unique functions. To correctly identify a circuit board the chip number should be used to identify it. It can be found on a white sticker near the center of the circuit board. Another number that is helpful in identifying a Balboa Water Group circuit board is the five digit number found on most boards (5****).
Warranty Coverage: Electronic circuit boards come with a six (6) months limited manufacturer's warranty that covers defects in workmanship and materials. This warranty will be void if these parts are damaged due to improper installation or use or if the damage is from exposure to water or electrical power surges. The warranty does not cover any labour charges, the cost of lost water or chemicals, or any other possible damages.
IMPORTANT. Heater and terminal block screws need to be tightened to torque to the specs listed on the inside cover of the pack. Failure to tighten properly can cause heat/resistance arc burn damage to the circuit board. The manufacturer will not honour the limited product warranty if these connection points are burned.
