The Balboa hot tub circuit board G1152 is a compatible replacement for the Coast Spas board circuit board P/N 55372 with chip number CS501Z, no modifications required, only on site configuration.
Details:
- Balboa P/N: G1152
- Can run, Pump1 = 2 Speed @ 120 or 220 Volts
- Can run, Pump2 = 1 Speed or Air Blower @ 120 or 220 Volts
- Can run Ozone - @ 120 or 220 Volts
- 12 volt output for light
- If running 2 pumps, total pump amps cannot exceed 12 amps each
Returns:
Hot Tub circuit boards are non-returnable items as they cannot be resold. All the replacement circuit boards we sell are factory-new, factory-tested and have never been installed before. For further information, please refer to our return policy. All circuit boards come with the original manufacturer's warranty.
Important Do not order or purchase a replacement Balboa circuit board on appearance alone, a number of the Balboa circuit boards look the same but have different software or operating chips on them and they are not interchangeable.
Warranty Coverage: Electronic circuit boards come with a six (6) months limited manufacturer's warranty that covers defects in workmanship and materials. This warranty will be void if these parts are damaged due to improper installation or use or if the damage is from exposure to water or electrical power surges. The warranty does not cover any labour charges, the cost of lost water or chemicals, or any other possible damages.
IMPORTANT. Heater and terminal block screws need to be tightened to torque to the specs listed on the inside cover of the pack. Failure to tighten properly can cause heat/resistance arc burn damage to the circuit board. The manufacturer will not honour the limited product warranty if these connection points are burned.
