This impeller has been discontinued. If this impeller is required, we recommend purchasing a complete wet end.
Current generation 1.5HP Replacement impeller for the Balboa Ultimax wet end. Impeller sleeve colors are : Green, Blue, Red, Blue.
Part Details:
- Ultimax 1.5HP impeller
- Fits 56 Frame 5 bolt Ultimax wet ends only
- Made by Balboa Water Group
- Stamped # 227
- Outer diameter : 3-13/16"
- Inner vane width : 1/2"
- Outer diameter front suction : 2-1/4"
- Back sleeve length : 1-15/16"
- Uses shaft seal PS-3868, Sold Separately here
- Also replaces part # PPUM15IMP
- Does not require a wear ring, a wear ring will not fit
The old generation of Ultimax pumps were made by Ultrajet up to about 2011. Balboa Water Group is now the manufacturer of these pumps and the replacement parts, most of these pump parts now made by Balboa are backwards compatible and should fit the older standard Ultrajet generation of the Ultimax series pumps
Manufacturer warrants product to be free of defects upon delivery.
