Gecko topsides come with a 10' cord which cannot be extended. If you need to have the topside of your hot tub located at an extended distance from the hot tub, the in.xtend modules allow you to run a standard CAT5 cable between the 2 units allowing to place the topside up to 300" (100M) away from the hot tub. Ideal for hot tubs that are built into the ground next to a swimming pool with the pumps in the pool house.
Bundle Includes:
- 1 Sending unit plugged into the pack i0608-521013
- 1 Receiving unit for the topside 0608-521014
- Please note CAT5 cable needed to run between the sending and receiving unit is not included
- Technical specs and installation details, Link opens in new window
The in.xtend is only compatible with the IN.XM2 and Y Series Gecko spa packs.
Only compatible with the following topsides n.k100, in.k300, in.k450, in.k600 static, in.k45, in.k56, in.k72, in.k73, in.k85.
How it works.
The Gecko in.extend bundle consists of 2 modules. One module is the transmitter which will be plugged in to the Gecko spa pack and be mounted by the spa pack. The second module is the receiver which will have the Gecko or Aeware keypad/topside plugged into it and be located were the keypad is located. In between the 2 modules a CAT5 cable will be run to connect both modules allowing the signals from the keypad to be sent to the spa control with out loosing signal strength. The maximum distance between these modules can be 100'.
