Balboa 54383-04 Replacement circuit board for VS511Z Spa Pack. Circuit Board only works with Balboa topside panels listed below. Compatible with optional expander board not included.
Will operate:
- Pump 1 = 2 Speed @ 120 or 220 Volts
- Pump 2 = 2 Speed @ 120 or 220 Volts
- Circ Pump @ 120 or 220 Volts*
- Ozone - @ 120 or 220 Volts*
- A/V @ 120 Volts
- Light @ 12 Volts
Compatible with the following topside controls only:
- VL200 P/N 53676 W/Overlay 11095
- VL401 P/N 54251 W/Overlay 11671
- VL402 P/N 54107 W/Overlay 10764
- VL403 P/N 54104 W/Overlay 10752
- VL404 P/N 51248 W/Overlay 10418
Returns:
Hot Tub circuit boards are non-returnable items as they cannot be resold. All the replacement circuit boards we sell are factory-new, factory-tested and have never been installed before. For further information, please refer to our return policy. All circuit boards come with the original manufacturer's warranty.
If you’re not sure which board is the correct replacement for your spa, please call us 1-877-845-1993 or text us a picture of your old circuit board 548-488-4942 and we’ll help.
* Circ pump and ozone must be same voltage.
Warranty Coverage: Electronic circuit boards come with a six (6) months limited manufacturer's warranty that covers defects in workmanship and materials. This warranty will be void if these parts are damaged due to improper installation or use or if the damage is from exposure to water or electrical power surges. The warranty does not cover any labour charges, the cost of lost water or chemicals, or any other possible damages.
IMPORTANT. Heater and terminal block screws need to be tightened to torque to the specs listed on the inside cover of the pack. Failure to tighten properly can cause heat/resistance arc burn damage to the circuit board. The manufacturer will not honour the limited product warranty if these connection points are burned.
