This kit includes parts specifically for the 3HP Waterway Hi-Flo wet-end and the 48 Frame electric motor.
Parts included:
- 1 - O-Ring for the hi-flo faceplate, Waterway Part # 805-0256
- 1 - Hi-Flo Impeller wear ring, Waterway Part # 319-1390
- 1 - 3HP Impeller specifically for 3HP Hi-Flo Pumps, Waterway Part # 310-4020
- 1 - Seal kit, professional grade for ozone and saltwater applications
- 1 - Slinger, Waterway Part # 313-1400
- 2 - 6203 Bearings, 40mm OD, 17mm ID (Shaft size), 12mm wide (always confirm the bearing size on your motor)
- 1 - Tube gasket and O-ring lubricant
- These parts only fit the Hi-Flo 48 Frame series Waterway pumps. Does NOT fit Executive 48 , Executive 56, EX2 or Viper series pumps.
When your hot tub pump needs to be rebuilt, consider purchasing a complete rebuild kit that replaces the main wear parts in your hot tub pump.
The parts in this kit are the main wear parts in all hot tub and pool pumps, pumps seals need replacing every 4 to 6 years with good water care, if the seal has been leaking then it's recommended to replace the parts in the pump included in this kit for even wear.
Replacing the bearings on the hot tub pump motor requires special tools to remove the bearings from the motor shaft as the bearings are pressure fitted (Pressed on the shaft). Attempting to replace the bearings without the proper tools could result is permanent damage to the new parts and motor / pump.
